When start up, it will load the following files
1. constant.mat for setting the constant value
2. configuration.mat, simulating the configuration value stored in the flash/eeprom

Files information:
------------------
Wiper_controller.slx - the main part for handling HI, LOW, INT_AUTO request
wiper.slx - model for demo the main part 
wiper_model.slx - the overall model
wiper_model_sim.slx - model for demo
wiper_model_test.slx - model for running test case
test_case.mat - holding the test cases
test_case.xlsx - export from test_case.mat
test.mldatx - holding the mapping
constant.mat - storing the system constant
configuration.mat - storing the configuration from eeprom/flash

Note: 
There is no SWIF_BdcOtaMod for checking the OTA mode

Program Note:
in INT mode, the model output WP_Front_Wiper_Enable_CMD the same as Front Wiper Motor in Figure 3 Front Wiper INT Mode in the specification. As not sure how to simulate the Front wiper motor.  

